Transition notes:

1. The following can stay from the previous lab:
   • All three of the black banana cords
   • Both of the red banana cords, you will need to add another one to make a total of 3 for this lab
2. Sweepy!

Equipment List:

1. USB-A to USB-Mini Cord
2. 850 Interface
3. Current Sensor
4. 2 x 8 pin DIN extension cable
5. Voltage Sensor
6. Circuit Board
7. 1 x D cell Battery
8. 3 x 2.25V light bulb (#222)
9. Spring Switch (AKA telegraph Switch)
10. 5 x 10cm Jumper Wire
11. 5 x 25cm Jumper Wire
12. Lab 5 Component bag:
• 5 x 33 Ohm Resistor
13. 3 x Red Alligator Cord (2 plugged into Current Sensors)
14. 3 x Black Alligator Cord (2 plugged into Current Sensors)
15. 4 x Red Alligator Clip (all but 1 attached to banana plugs)
16. 4 x Black Alligator Clip (all but 1 attached to banana plugs)

Notes and tests:

1. Put only one “D” cell that tests at 80% or higher in the battery holder for this lab. It will need to be replaced for the next lab. The cell must be fresh. We should not store cells in holder so we don’t confuse old cells with new.
2. Check that the correct number of jumper wires and components are in all of the bags. Spare bulbs and resistors should be on the Spares cart.
3. Test the voltage sensor and current sensors with the test file "2306 Lab5 test.cap" by setting up a simple circuit with the battery and a bulb.
4. Current sensors that look burnt have been refurbished on the inside, don't worry about it.