This needs to be replaced with a more fun image
Equipment List:
- 2216 Circuit Board with:
- 10 Volt Bulb in Socket A.
- 2 x Long Jumper Wire in the component holder.
- 4 x Short Jumper Wire in the component holder.
- 3 x 100 nanoFarad Capacitor in the component holder.
- 1 Pair of Large Aluminum Plates
- 1 Pair of Small Aluminum Plates
- 1 Pair of Plexiglass Plates
- Large "Soda Can" Capacitor
- LCR Meter with Leads
- Autorange DMM This may not be needed, please Tell Henry to check
- Current Limited Power Supply
- Vernier Caliper
- 30 cm ruler
- 1 sheet of 11" x 17" paper. With a stapled stack of 10 and extra on the TA counter please.
- Red banana plug cord
- Black banana plug cord
- Black alligator clips
- Red alligator clips
- 2 x Red Alligator to Alligator.
- 2 x Black Alligator to Alligator.
Notes and tests:
- Test the bulbs, meters, and power supplies.
- To test the capacitance meters measure the capacitance of the aluminum plates. Set the multimeters to the 4 nF scale.
Transition Notes: (Summer Only)
- Leave out the multimeters.
- Put away everything else.